
Edimax Technology Europe BV
Created on 21/08/2006 09:20:00
Page 1 of 2
1
To setup EW-7206ApG or EW-7209ApG as a Repeater, please do the following:
First Step: Make sure you have the latest firmware available from our website.
The AP is not configured to assign IP-addresses, therefor we need to (temporarily) assign
one manually to your networkcard. (Wired or wirelessly, for flashing firmware we advice a
wired connection to your AP)
1) Go to “Control Panel”, “Network Connections” right-click your networkcard, go to it's
Properties, select “Internet Protocol (TCP/IP)”, click on “Properties”.
Select “Use the Following IP Address”, enter 192.168.2.2 as IP-address and subnet-
mask is 255.255.255.0. (Filled in automatically) Click “OK” and “OK” to save the
setting. (This can take a while.)
2) Logon to your AP; Open Internet Explorer, and surf to 192.168.2.1
Username = “admin” and password = “1234”
Click on “Upgrade” and browse to the bin file on your computer. (Download the
latest firmware from www.edimax.eu). Wait for the upgrade and reset.
3) When done, do a hardware reset! (To reset, press and hold the reset-button at the
back of the AP for 15 seconds and power it off and back on again.)
Second Step: Change the IP address of EW-7206APg according to your router.
4) Logon to your AP; Open Internet Explorer, and surf to 192.168.2.1
Username = “admin” and password = “1234”.
Click on “System Utility”, change the IP-address into your router’s IP range, subnet
mask and default gateway is your router’s IP address. (For example, 192.168.2.50,
255.255.255.0, 192.168.2.1). – You need to know what IP Address you can allocate
to your AP.
Kommentare zu diesen Handbüchern