Edimax N-9210TX-64 Installationsanleitung PDF herunterladen (Seite 6)

root wireless access point) and attempting to open a web page with your

web browser.

6. After you have connected the extender to the existing Wi-Fi network and

confirmed it works, you can move this extender to another location for

optimal Wi-Fi extension. To move the extender, turn off the device and

unplug it from its socket. The extender will remember the Wi-Fi network it

is assigned to. Move the extender to its new location and plug it in, then

turn the device on again. The extender will go through its initialization

process after being turned on. You will be unable to connect to the

extender while it is initializing. When the green Wi-Fi LED ( ) begins

flashing irregularly and the orange Signal Strength LED ( ) activates, the

extender is ready for use.

For best results, install the extender at a location where the Signal Strength

LED ( ) remains on without blinking. This indicates the extender is

receiving a strong signal from the root wireless access point.

Section B: Setting Up the Wi-Fi Extender with a Computer

1. First make sure that your computer is a DHCP client (it obtains its IP

automatically from a DHCP server). If you are unsure, please refer to the

User Manual on the enclosed CD.

2. Plug the Wi-Fi extender into a power outlet close to the root wireless

access point and switch it on (1). The extender will automatically initialize.

In a few seconds, the Power LED ( ) will light up. Approximately 30

seconds afterwards, the Wi-Fi LED ( ) will begin to flash rapidly and

irregularly (2). This indicates initialization is complete. Please do not

proceed to step 3 until these conditions are fulfilled.

(1)

(2)

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Keine Kommentare

Edimax N-9210TX-64 Installationsanleitung Seite 6