Edimax AC-M1000 Bedienungsanleitung PDF herunterladen (Seite 14)

Compliance Certification Services Inc.

Report No.: 70125004-D Date of Issue: January 29, 2007

Page 14 Rev. 00

Procedure of Final Test

 EUT and support equipment were set up on the turntable as per step 8 of the preliminary

test.

 The Analyzer / Receiver scanned from 30MHz to 40GHz maximum, if any. Emissions

were scanned and measured rotating the EUT to 360 degrees, varying cable placement and

positioning the antenna 1 to 4 meters above the ground plane, in both the vertical and the

horizontal polarization, to maximize the emission reading level.

 Recorded at least the six highest emissions. Emission frequency, amplitude, antenna

position, polarization and turntable position were recorded into a computer in which

correction factors were used to calculate the emission level and compare reading to the

applicable limit and only Q.P. reading is presented.

 The test data of the worst case condition(s) was recorded.

Data Sample:

Frequency

(MHz)

Reading

(dBuV)

Correction

Factor

(dB/m)

Result

(dBuV/m)

Limit

(dBuV/m)

Margin

(dB)

Degree

(。)

Height

(cm)

Remark

xx.xx 16.49 9.86 26.35 30.00 -3.65 116.00 101.00 QP

Frequency (MHz) = Emission frequency in MHz

Reading (dBuV) = Uncorrected Analyzer / Receiver reading

Correction Factor (dB/m) = Antenna factor + Cable loss – Amplifier gain

Result (dBuV/m) = Reading (dBuV) + Corr. Factor (dB/m)

Limit (dBuV/m) = Limit stated in standard

Margin (dB) = Result (dBuV/m) – Limit (dBuV/m)

Q.P. = Quasi-Peak

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Edimax AC-M1000 Bedienungsanleitung Seite 14